Will Burt INFLEXION HD, Instructions Manual

Page: 53 / 84

I
NSTRUCTIONS FOR
N
IGHT
S
CAN
L
ITE
& I
NFLEXION
HD
TP-5554501-B Original Instructions 2-21
May 2019
position, adjust the sensor 1 mm closer to the moving base section and tighten the nut to 67-80
N·m. Ensure the lock washer is seated on both sides. The end of the sensor should be
approximately 5 mm away from the moving base section after adjustment. A second sensor
hole is provided on the opposite side of the mast. The sensor can be moved to the other side if
it is more convenient for installation. Follow the adjustment procedure when moving the sensor
to the other side if necessary.
Figure 2-15 Proximity Sensor
Proximity Sensor Specifications:

10-30VDC Input Power

100 mA max

Normally Open (closes when mast is nested)

NPN

7mm sensing range

IP 65/66/67/68/69K
The following diagram (Figure 2-16) shows a possible Vehicle Interlock circuit. Other
arrangements can also be constructed. The customer is responsible for choosing the proper
components and providing power to the circuit. The proximity sensor switch is closed when the
mast is nested.
The customer-supplied proximity sensor cable and mating connector are as follows:

Standard female M12x1 Sealed 4-Socket Connector

Wire 22 AWG (0.5 mm
2
)
Base
Proximity
Sensor
Approximately
5 mm Spacing
Proximity
Sensor
LED
Indicator
M12x1 4-Pin