Will Burt INFLEXION HD, Instructions Manual

Page: 58 / 84

I
NSTRUCTIONS FOR
N
IGHT
S
CAN
L
ITE
& I
NFLEXION
HD
2-26 Original Instructions TP-5554501-B
May 2019
Figure 2-21 12VDC Input Power Wiring
2.6.2.7 Wire Power for Mast and Control to Power Relay Board
The mast and control require a 20-30 VDC power supply with a nominal power of 24 VDC. The
system may have an amp draw of up to 20 amps. To wire customer power for the mast and
control:
1. Run a 10 AWG cable (6 mm
2
) (maximum length 15 meters) from customer power to the
Control Box Assembly through one of the cable grips on the side of the control box. Use
10/2 SJOW or equivalent wire. This cable is typically customer supplied, but available as
P/N: 218073 specified by length or P/N: 5594101 for a 15 meter (50 ft.) length cable.
2. Locate terminal block TB1 on the Power Relay Board (P/N: 5553301).
3. Secure the wire to TB1 as shown in Figure 2-22.
Figure 2-22 Power Relay Board Terminal Block TB1