Will Burt INFLEXION HD, Instructions Manual

Page: 40 / 84

I
NSTRUCTIONS FOR
N
IGHT
S
CAN
L
ITE
& I
NFLEXION
HD
2-8 Original Instructions TP-5554501-B
May 2019
2.5 Power Supply Requirements
The mast control system:

Requires a 20-30 VDC power supply for the mast control system

Requires 10 AWG Wire (6 mm
2
) or heavier power cable with maximum length of 15
meters (50 ft.), 10/2 SJOW cable or equivalent

Has a nominal power of 24 VDC

May have an amp draw of up to 20 amps including inrush current

Contains overcurrent protection and reverse polarity protection
o
Fuse to Actuator: 25A 32VDC Blade Mini (P/N: 0297025 U)
o
Fuse to PCB: 2A 32VDC Blade Mini (P/N: 0297002 U)
o
Fuse to Relay Board: 5A 32 VDC Blade Mini (P/N: 0297005 U)
The X200 LED Lights:

Requires a 20-30 VDC power supply

Requires 10 AWG Wire (6 mm
2
) or heavier power cable with maximum length of 15
meters (50 ft.), 10/2 SJOW cable or equivalent (four light models require qty(2) 10/2
SJOW cables
– one to supply the left side and one for the right side)

May have an amp draw of up to 40 amps (for four lights) (20 amps per side)

Requires customer supplied 20 amp fuse per side or breaker-protected source (mast
control system does not contain overcurrent protection for light circuits)
If used, auxiliary devices:

Can use up to a 28 VDC power supply

Requires 14 AWG Wire (2.5 mm
2
) or heavier power cable with maximum length of 15
meters (50 ft.)

May have an amp draw of up to 10 amps per device

Requires customer supplied 10 amp fused or breaker-protected source (mast control
system does not contain overcurrent protection for auxiliary circuits)
During installation, the power supplies will be connected at the Control Box Assembly through a
cable grip and wired into a terminal block on the Power Relay Board (Section 2.6.2).