COMPONENT ACCESS
3-12
n
Vesta Gas and Electric Slide-In Ranges
Removing a Cooktop Element and
Limiter Assembly
1. Remove the cooktop (see “Removing the Cooktop”
section)
2. Disconnect the electrical connections to the element
. Lift the element up o the spring supports
Removing the Oven Sensor,
Thermofuse, Terminal Block & Door
Switch
1. From behind the range, remove the upper access cover.
2. Locate the desired component and remove the wires/
disconnect plug.
. Remove mounting screws.
4. Pull the component out the back of the oven.
Door Switch
Terminal
Block
Thermofuse
Opens
Oven Sensor
4. Pull broil element toward front of oven until electrical
connections are visible through back wall of oven
. Remove electrical connections (do not let wires slip out
rear wall).
6. Pull element out.
Removing the Broil Element
1. Open oven door. (this may be easier to do if the door is
removed)
2. Locate the broil element at the top of the oven cavity.
. Locate and remove mounting screws (2 in ceiling and 1
on back wall.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Figure 35
Figure 36
Figure 37
Figure 38
