WFT08X
INSTRUCTION
HELICOPTER
Advanced curve setting: User can add or delete the curve point.
D/R curve has 7 points and every point can be set. Press +/-
button for seconds can add/delete curve point. It can at most add
to 7 points and delete to 2 points.
When selecting one point, use left/right button to choose the
point you want to edit, press OK button to enter editing.
Active the cursor, use up/down direction button to set the left
value in the pane, use left/right direction button to set the right
value in the pane.
The black cursor is the editing part, which is marked by a dashed
line.
59
3
.
The operation method Of incresing
、
decreasing
、
moving
the curve points
(1) Increase the curve point
Open the transmitter entre into No.17 advanced setting→confirm→select
No.9 curve setting→ select No.2:Advanced→confirm→exit→exit→select
No.8 throttle curve setting→confirm → At this point we can see a row of
number in bottom left corner inside the box (that is, two 0.0%) are black
shadow → at this time press confirmation button, the black shadow, this
is the cursor (we will introduce it with cursor as follows) will coruscate→
Hold down the (+) key until hear two beeps
(
At this time the position
0.0% has increased one curve point, which means that the position 0.0%
have two curve points, of course, there is no need to have two curve
points in one position, so the introduction of how to move curve point will
be shown later
)
→ Press confirmation button to let cursor stop blinking
→Press the right key to move the curve point to +16.7% → Press
confirmation button, the cursor blink → Hold down the (+) key until hear
two beeps
(
At this time the position 0.0% has increased one curve
point
)
→ That means there are two points have been increased, then
about the third curve point, put the cursor in +33.3% position with the
same operation in accordance with the above can be, and there are
seven curves of the original design point, a maximum of can be set to 10
curve points, that is, 3 points can be increased.