ActiveScale™ P100 Support Guide
110
1. Connect an Ethernet cable from your laptop to port 44 on System Interconnect 1.
2. Configure your computer to be on the same network as the System Interconnect using the following
values:
– Management Port:
192.168.123.0/24
– Subnet:
255.255.255.0
– Gateway:
192.168.123.123
3. Open a
Telnet
session to the System Interconnect and replace
switchport_IP
with the default
IP address
192.168.123.123
.
The System Interconnect command prompt appears.
4. Log in using the default credentials:
–
User name:
admin
– no password
5. Type
enable
to enter the Privileged EXEC command mode.
6. Type
configure
to enter the Privileged CONF command mode.
7. Open the required ports for the System Expansion Node:
Important:
If you are installing more than one System Expansion Node, open
the necessary ports on both System Interconnects before continuing to the next
node.
d. System Expansion Node 1
(
Routing
)>
enable
(
Routing
)#
configure
(
Routing
) (
Config
)#
en
conf
interface 0/38
no shutdown
exit
exit
write memory confirm
Config file 'startup-config' created successfully. Configuration Saved!
Summary of Contents for ActiveScale P100
