Wenglor SEFB Series, Operating Instructions Manual

Page: 140 / 161

Servicing 140
12.3 Regular Inspections
• The described checks are intended to confirm compliance with national / international safety regulations.
NOTE!
• Regulations governing operator induction by specialist personnel must be observed
before work is commenced.
• The company which operates the machine is responsible for training.
• Regular inspections must be conducted by a person who has been authorized and engaged to do so by
the company which operates the machine when work begins, and whenever a new shift is started.
• The check takes place according to the regular inspection checklist (see section 16.1.3, page 150 )
DANGER!
• Work on the machine must be immediately stopped if any impairment of the safety func-
tion is detected.
• Once the situation has been resolved, the effectiveness of the ESPE must be checked
again according to the checklist for initial start-up (see section 16.1.1, page 148).
NOTE!
• The supplied sticker “Instructions for regular inspection” must be mounted in a clearly
visible location close to the relevant ESPE.
• Do not clean the ESPE with solvents or cleaning agents which could damage the device
(aggressive, abrasive, scratching) (see section 12.2, page 139).
12.4 Annual Inspection
• The described tests are intended to confirm compliance with national / international safety regulations.
NOTE!
• Regulations governing operator induction by specialist personnel must be observed
before work is commenced.
• The company which operates the machine is responsible for training.
• The inspection must be carried out annually or within the required deadlines according to the valid national
regulations.
• The check takes place according to the annual inspection checklist (see section 16.1.2, page 149 )
DANGER!
• Work on the machine must be immediately stopped if any impairment of the safety func-
tion is detected.
• Once the situation has been resolved, the effectiveness of the ESPE must be checked
again according to the checklist for initial start-up (see section 16.1.1, page 148).