Wenglor SEFB Series, Operating Instructions Manual

Page: 5 / 161

Multi-Beam Safety Light Array 5
9. Parameters Configuration 92
9.1 General 92
9.2 Preparation of the Parametrization 92
9.3 Parametrization of the Emitter 92
9.3.1 Default Settings 93
9.3.2 Calling up the Menu (User Level “Admin”) 93
9.3.3 Menu Structure 94
9.3.4 Parametrization of the Range and Coding 94
9.4 Parametrization of the receiver with basic function (without display) 95
9.4.1 Default Settings 95
9.4.2 Calling up the Menu (User Level “Admin”) 95
9.4.3 Menu Structure 96
9.4.4 Parametrization of the Restart Inhibit, Contactor Monitoring and Coding 97
9.5 Parametrization of the receiver with muting (with display) 98
9.5.1 Default Settings 98
9.5.2 Parametrization of the Restart Inhibit (RES) 101
9.5.3 Parametrization of the Contactor Monitoring (EDM) 101
9.5.4 Parametrization of the Beam Coding (CODE) 102
9.5.5 Parametrization Cascading (CASC) 103
9.5.6 Parametrization Muting (MUTG) 104
9.5.6.1 Parametrization Cross Muting (X) 105
9.5.6.2 Parametrization Two Sensor Linear Muting (2L) 108
9.5.6.3 Parametrization Four Sensor Linear Muting with Sequence (LSEQ) or Time Monitoring
(LTME) 111
9.5.7 Setting the Display (DISP)
114
9.5.8 Expert Menu (EXPT) 115
9.5.9 Saving the Configuration and Restart (RUN) 120
9.6 Parametrization via the IO-Link Interface 121
9.6.1 Requirements and Framework Conditions 121
9.6.2 Process Data 123
9.6.3 Parameter Data 124
9.6.4 Example for Setting the Parameter Data 125
9.6.5 Data Storage 126
10. Initial Start-Up 127
10.1 Overview 127
10.2 Switching On 127
10.3 Aligning the Emitter and Receiver 128
10.4 Check for initial start-up 130