Wenglor SEFB Series, Operating Instructions Manual

Page: 98 / 161

Parameters Configuration 98
9.5 Parametrization of the receiver with muting (with display)
The parameter configuration directly on the sensor takes place via the push buttons on the control panel.
Receiver
Menu down Menu up Apply
NOTE!
• If the parameter configuration is interrupted (e.g. due to an interruption in the power
supply), this causes the newly selected settings to be lost. In this case, the most recently
saved settings are active.
• To save changes to the parameter configuration permanently, the save function (see
section 9.4.12, page 151) must be used to write them to the device memory via RUN

SAVE. Otherwise, the changes will be lost when the device is restarted.
9.5.1 Default Settings
Function Default settings
Restart inhibit Off (safety operating mode / automatic restart)
Contactor Monitoring Off
Beam coding Off
Cascading Off
Muting Off
When muting is activated:
• Muting duration 300 s
• Belt stop function Off
• Muting enable Off
• Direction setting Off
• Muting end through clearing of the
ESPE
Off
• Partial muting Off
• Full Muting Enable Off
• Gap suppression Off
• Override Off
Display and expert menu:
Display
Energy saving mode
Signal output Acknowledgment prompt restart inhibit
Indicator lamp Muting
Password protection Active, 0000