Welch Allyn PneumoCheck 61000, Service Manual

Page: 47 / 90

46 Pneumocheck Handle and Printer/Charger Service Manual 610132 Rev. E
No % Or Norms on Printout
Page 54 in Operating Instructions
cont’d
Pneumocheck handle is in test mode-you will
received no % norms in the print-Turn on w/out
buttons depressed. Remove handle-turn unit off turn
handle on into normal mode.
They may have blown a fuse.
No Power to Printer
No Print on Printout
Make sure the paper is inserted correctly.
If cannot be corrected, printer must be returned for
service.
Paper Replacement
Remove printer cover.
Feed any remaining paper through printer. DO NOT
PULL PAPER BACKWARDS THROUGH THE
PRINGER.
Save black plastic spindle.
Put red lever all the way forward.
Place new roll of paper in the printer well. The paper
feeds forward from the bottom of the roll.
Insert edge of paper under the gray rubber pinch
roller until paper exits top of printer.
Push red lever as far back as possible.
Press FEED button to feed paper through.
Replace printer cover.
The printer does not store
more than one patients Data
The printer saves only the
best test.
If the doctor wants a printout of all the tests on a
patient, they have to run a test, print it out, then turn
off the Pneumocheck and start over again as a new
test.
THE PNEUMOCHECK HANDLE SHOULD BE LEFT
IN THE OFF POSITION TO KEEP THE BATTERY
FULLY CHARGED AT ALL TIMES. THE PRINTER
SHOULD BE LEFT PLUGGED IN.
Section 4 -Troubleshooting