Welch Allyn PneumoCheck 61000, Service Manual

Page: 45 / 90

44 Pneumocheck Handle and Printer/Charger Service Manual 610132 Rev. E
Infrequently customer complains of Error 23. Have
them turn handle off/on to see if it will reset-perhaps
leave for a couple minutes and try again. In talking
the Tech. Rep., they have not been able to duplicate
problem inhouse. Customer must return both
handle and printer for service.
Error 23
Error 25 Or Temp. Lim
This is a temperature problem.
Is the office extra warm (cold) today?
Is the unit sitting in direct sun, near heat register,
etc.?
Advise to put the handle on the desk for a minute
before attempting a test - it should be OK.
If the error message continues and creates a problem
they may return handle for new software update (3.5)
It was also discovered Error 25 could indicate low
battery. Change batteries.
The amount of air that can be exhaled during a rapid
forced exhalation. (1 long, hard blast)
Forced Vital Capacity
Getting the Wrong Graph
Have them check the bottom of the printer, “flip” the
4th switch the opposite way, and see it that corrects
the situation.
Green Data Light on Printer
This indicator light will be lit as long as there is
information on the printer.
If they want to clear the printer entirely, it must be
unplugged.
If the customer has entered incorrect data in the
height or age, and the patient data is still in the
printer, all they need to do is insert correct info and
push print.
Section 4 -Troubleshooting