7
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
Tools Needed:
iNST
alla
Tio
N
None
attaching Fully adjustable
Flagangle to vertical Track
hand tighten the flagangle to the vertical track
using (2) 1/4” - 20 x 9/16” track bolts and
(2) 1/4” - 20 flange hex nuts. Repeat for other
side.
Secure the flange nuts after flagangle spacing is
complete (Step 14).
1
(2) 1/4”- 20 flange
hex nuts
fully adjustable
flagangle
Vertical track
(2) 1/4”- 20 x 9/16”
Track bolts
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and header must be leveled. Side clearance, from edge of
door to wall, must be a minimum of 3-1/2” (89mm) on each side.
imPoRTaNT:
STAINLESS STEEL OR PT 2000 COATED LAG SCREWS MUST BE USED WhEN INSTALLING CENTER BEARING BRACkETS, END BRACkETS, jAMB BRACkETS, OPERATOR
MOUNTING/SUPPORT BRACkETS AND DISCONNECT BRACkETS ON TREATED LUMBER (PRESERVATIVE-TREATED). STAINLESS STEEL OR PT 2000 COATED LAG SCREWS ARE NOT
NECESSARY WhEN INSTALLING PRODUCTS ON UN-TREATED LUMBER.
imPoRTaNT:
WhEN INSTALLING 5/16” DIAMETER LAG SCREWS USING AN ELECTRIC DRILL/DRIVER, ThE DRILL/DRIVER’S CLUTCh MUST BE SET TO DELIVER NO MORE
ThAN 200 IN. LBS. Of TORqUE. fASTENER fAILURE COULD OCCUR AT A hIGhER SETTING.
NoTe:
It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit, prior to fastening.
installation
2
Position the horizontal angle as shown. Place tabs
of horizontal angle in the key slot of horizontal track.
Using a hammer, tap the horizontal angle towards the
curved end of the track until the holes in track and
angle are aligned. Set tracks aside.
NoTe:
for larger doors, a full length horizontal angle
may be spot welded to the horizontal track. If the
horizontal angle is not welded, the horizontal angle
must be installed as shown.
horizontal angle
hammer
horizontal
track
horizontal angle
horizontal angle
horizontal track
hole
hole
Tabs
key slots
horizontal
track
Tabs
horizontal
track
horizontal
angle
key slots
