17
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
iNST
alla
Tio
N
(1) 3/8”- 16 X 3/4”
Truss head bolt
(1) 3/8”- 16
hex nut
flagangle
horizontal angle
(2) 1/4”- 20
flange hex
nuts
flagangle
(2) 1/4”- 20 X 9/16”
Track bolts
Adjustable horizontal
track
NoTe:
Refer to illustrations (A) or (B) to determine
which horizontal track was supplied with your door.
follow the corresponding step below:
For adjustable horizontal track (a):
To install
horizontal track, place the curved end over the top
roller. Align the bottom of the horizontal track with
the vertical track. hand tighten the horizontal track
to the flagangle with (2) 1/4”- 20 x 9/16” track bolts
and (2) 1/4”- 20 flange hex nuts.
For quick install horizontal track (b):
To install
horizontal track, place the curved end over the top
roller. Align the bottom of the horizontal track with
the vertical track. hand tighten the horizontal track
to the flagangle with (1) stud plate and (2) 1/4”- 20
flange hex nuts.
DO NOT RAISE DOOR UNTIL hORIzONTAL TRACkS
ARE SE CURED AT REAR, AS OUTLINED IN STEP 25,
OR DOOR COULD fALL fROM OVERhEAD POSITION
CAUSING SEVERE OR fATAL INjURY.
Level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle using
(1) 3/8”- 16 x 3/4” truss head bolt and (1) 3/8”- 16
hex nut. Repeat for other side. Tighten flange nuts to
secure horizontal tracks to flagangle. Remove the nail
that was temporarily holding the top section in place,
installed in Step 14.
imPoRTaNT:
failure to remove nail before attempting
to raise door could cause permanent damage to top
section.
waRNiNg
15
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
hammer
flat Tip
Screwdriver
Step Ladder
attaching horizontal Track to
Flagangle
(2) 1/4”- 20
flange hex
nuts
flagangle
(1) Stud plate
q.I. horizontal track
(A)
(B)
