13
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
Tools Needed:
iNST
alla
Tio
N
LIfT hANDLE INSIDE
LIfT hANDLE OUTSIDE
10
lift handle
NoTe:
Doors with a keyed lock do not require this
lift handle.
NoTe:
for door section identification see page 4.
Locate the inside center most stile or the desired lift
handle location on the lock (2nd) section of the door.
Position the lower hole in the lift handle 4” from the
bottom of the second section.
Vertically align the lift handle, use the lift handle as a
template and mark the hole locations on the section.
Drill (2) 9/32” dia. holes through section. Enlarge the
holes from outside the door to 1/2” dia.
Assemble the outside and inside lift handle to the
section using (2) 1/4” x 2-1/2” carriage bolts and
nuts and (2) spacers.
NoTe:
Do not drill through or enlarge holes on the
inside of the door.
TO AVOID POSSIBLE INjURY, LIfT hANDLES ThAT
ARE INSTALLED WIThIN 4 INChES (102 mm) Of A
SECTION INTERfACE ShALL PROMOTE VERTICAL
ORIENTATION Of ThE hAND.
Tape Measure
Pencil
Power Drill
9/32” Drill Bit
1/2” Drill Bit
7/16” Wrench
Lock section
Lock section
Lock
section
Bottom
section
Bottom
Section
Bottom section
Lift handle
Lift handle
Lift handle
(2) Spacers
(2) 1/4”-20
hex nuts
(2) 1/4” x 2-1/2”
Carriage bolts
4”
Enlarge holes on
outside of section to
1/2” diameter.
4”
9/32” Diameter
holes (do not
enlarge holes).
11
bottom Section
Center the bottom section in the door opening.
Level section using wooden shims under the bottom
astragal if necessary. hold the section in the opening
while attaching vertical tracks.
Level
Wood Shims
Level
header
jamb
Bottom
section
Wooden
shims
Weather seal
waRNiNg
