18
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
Tools Needed:
Correct
Incorrect
wiNDloaD oPTioN coDeS 1320 aND 1340
wiNDloaD oPTioN coDe 1300
Top bracket
slide
Top bracket
assembly
Top section
horizontal
track
Top
roller
(1) 1/4” - 20 X 9/16” Track bolt and (1) 1/4” - 20 flanged hex nut
(1) 5/16” - 18 Nut
16
With horizontal tracks installed you can adjust the
top brackets. Vertically align the top section with the
lower sections. Once aligned, position the top roller in
top bracket slide(s), out against the horizontal track.
For windload option code 1300:
Maintaining the slide’s position, tighten the (1) 5/16”
- 18 nut to secure the slide to the top bracket. Next
lock the top slide into place on the top bracket using
(1) 1/4” - 20 x 9/16” track bolt and (1) 1/4” - 20 hex
nut through any two aligning holes. Insert short shaft
roller into the slide. Repeat for other side.
For windload option codes 1320/1340:
Maintaining the slide’s position, tighten the (2)
5/16” - 18 nut to secure the slide to the top bracket.
Next lock the top slide into place on the top bracket
using (2) 1/4” - 20 x 9/16” track bolt and (2) 1/4”
- 20 hex nut through any two aligning holes. Insert
long shaft roller into the slides. Repeat for other side.
adjusting Top brackets
7/16” Wrench
Step Ladder
Short shaft
roller
(2) 1/4” - 20 X 9/16” Track bolts and (2) 1/4” - 20 flanged hex nuts
(2) 5/16” - 18
Nuts
Top
roller
Top bracket
slide
Top section
horizontal
track
Top bracket
assembly’s
Long shaft
roller
Top bracket
slide
17
NoTe:
If you have windload option code 1300 or
1340, skip this step and continue with Step 18. If not,
complete this step.
imPoRTaNT:
ACCURATELY POSITIONING ThE
PUShNUT ONTO ThE ROLLER STEM IS CRITICAL.
ONCE ThE PUShNUT IS PUShED ONTO ThE ROLLER
STEM, ThE TABS MAkING CONTACT WITh ThE STEEL
SURfACE, WILL MAkE IT DIffICULT TO REPOSITION
ThE PUShNUT.
NoTe:
When positioning the pushnut onto roller stem,
ensure the tabs on the pushnut are pointing away
from roller stem.
Starting with the right top bracket assembly, slide (1)
pushnut over the roller stem and push the pushnut
towards the outside edge of top bracket assembly
leaving 1/4” spacing between the outside edge of top
bracket assembly and pushnut.
Repeat same process for the end hinges on the left
hand side of door, then repeat same process for the
right hand side of door.
Pushnuts
Step Ladder
Tape Measure
Top section
Pushnut
Roller
stem
Top bracket
assembly’s
Tabs
1/4” Spacing
