Waygate Technologies Krautkramer USM 10, Operating Manual

Page: 149 / 242

Defining the probe angle 5 Operation
Krautkrämer USM 100 Rev. - (09/2021) 149
5.17 Defining the probe angle
The function group Probe Angle on the Probe Angle
Cal. panel provides all functions to define the current in-
dex angle of a probe on a reference block. The current
probe index angle is influenced, e.g. by different materi-
als or by the wear of the probe contact face.
ATTENTION
You have to carry out calibration (see from
page 145) before defining the probe angle.
– After calibration, select the Probe Angle Cal. panel
and switch to the function group Probe Angle (see
page 136).
– Select Block and choose the used calibration block.
– Check the values of SDH Diameter and SDH Depth
and correct them if necessary.
– Couple the probe to the calibration block.
– Shift the gate to the calibration echo.
– In the Command bar tap on Calibrate (see page 66)
to execute the calculation.
The calculated angle is briefly displayed in the informa-
tion line at the bottom edge of the display screen.