Wavelength Electronics LFI-3751, User Manual

Page: 113 / 132

4
113
Chapter 4 - Remote Interface Reference
Calibration - Measurement Slopes & Offsets
Calibration - Measurement Slopes & Offsets
•
All measurements are calibrated at the factory. To change these
calibrated values, you must fi rst send the [PASSWORD] command.
You should not use these commands without direct supervision from
Wavelength Electronics Technical Support Group.
Write
!101254????????(FCS)
( [PASSWORD] )
Calibrating ACT T Slope & Offset
•
These commands are used to calculate the instrument’s ACT T
measurement.
Write
!001.00024
( [ACT T SLOPE CAL] )
!000.00024
( [ACT T OFFSET CAL] in Volts)
Calibrating TE I Slope & Offset
•
These commands are used to calculate the instrument’s TE I
measurement.
Write
!001.00026
( [TE I SLOPE CAL] )
!000.00026
( [TE I OFFSET CAL] in Amps)
Calibrating TE V Slope & Offset
•
These commands are used to calculate the instrument’s TE V
measurement.
Write
!001.00028
( [TE V SLOPE CAL] )
!000.00028
( [TE V OFFSET CAL] in Volts)
RS-232
Commands Discussed:
[PASSWORD]
[ACT T SLOPE CAL]
[ACT T OFFSET CAL]
[TE I SLOPE CAL]
[TE I OFFSET CAL]
[TE V SLOPE CAL]
[TE V OFFSET CAL]