Wallace Perimeter Security ALPHA, Installation And Maintenance Manual

Page: 90 / 182

90
wallaceperimetersecurity.com
Phone: 866.300.1110
ADJUSTING THE CLOSE TIMER
Adjusting the Close Timer
The close timer assigns how many seconds will pass before the operator initiates closure of a fully opened
gate after all open commands and reversing sensor inputs have ceased. Every gate operator needs to have
the close timer set to a specific number of seconds unless a hard-wired closing device is connected to the
unit such as a push-button station.
To adjust the time (1 to 99 seconds) it takes before the operator initiates gate closure, take the following
steps:
1� At a gate status display, press the MENU button twice.
This accesses the User Menu and the CLOSE TIMER display appears.
2� Use the SELECT and then NEXT or PREV buttons to navigate and change the number on the display.
3� To exit the User Menu, press the MENU button.
The gate status appears in the display indicating you have returned to Run Mode.
Keep the close time at zero if gate
personnel operate the gate or the
owner plans to use a remote control.