94 Commissioning
WAGO I/O System 750 XTR
750-495/040-010 3-Phase POM 20KV 300A XTR
Manual
Version 1.0.0
8.2.4
“Factory Settings” Tab
On the “Factory Settings” tab, you can reset all parameters of the I/O module to
the factory settings after entering the password.
The initial password is “wago”. After the first use, please change this password
using [
Change password
].
If you have forgotten the password, you can uninstall and reinstall the plug-in for
the 3-Phase Power Measurement Module. This resets the password to the initial
password.
List of the factory settings
You can find a list of the factory settings in “Appendix” > “Factory Settings.”
•
Module settings
[
Restore
] restores only the I/O module settings.
Calibration data remains unaffected.
•
Calibration data
[
Restore
] restores only the calibration data. The
I/O module settings remain unaffected.
•
Total [Restore]
can be used to restore all I/O module settings and
calibration data.
These actions are performed immediately and cannot be reverted.
Therefore, the [
Save
] button at the bottom of the window is disabled.
