WAGO I/O System 750 XTR
Mounting 73
750-495/040-010 3-Phase POM 20KV 300A XTR
Manual
Version 1.0.0
Pos: 75 /Alle Serien (Allgemeine Module)/Überschriften/Ebene 2/Geräte einfügen und entfernen - Überschrift 2 @ 3\mod_1231768483250_21.docx @ 25950 @ 2 @ 1
6.2
Inserting and Removing Devices
Pos: 76 /Alle Serien (Allgemeine Module)/Sicherheits- und sonstige Hinweise/Gefahr/Gefahr: Nicht an Geräten unter Spannung arbeiten! @ 6\mod_1256193963573_21.docx @ 43426 @ @ 1
Do not work when devices are energized!
High voltage can cause electric shock or burns.
Switch off all power to the device prior to performing any installation, repair or
maintenance work.
Pos: 77 /Alle Serien (Allgemeine Module)/Sicherheits- und sonstige Hinweise/Vorsicht/Vorsicht: Heiße Oberfläche nicht berühren! (allgemein) @ 6\mod_1264428115588_21.docx @ 48610 @ @ 1
Do not touch hot surfaces!
The surface of the housing can become hot during operation. If the device was
operated at high ambient temperatures, allow it to cool off before touching it.
Pos: 78 /Serie 750 (WAGO I/O SYSTEM)/Wichtige Erläuterungen (alte Struktur)/Sicherheits- und sonstige Hinweise/Achtung/Achtung: XTR nicht unter -
20 °C verdrahten oder umstecken @ 15
\mod_1367559895186_21.docx @ 118480 @ @ 1
Temperature range applies to normal operation!
XTR I/O modules may be operated below −20 °C, but not wired and/or
reconnected.
Pos: 79 /Serie 750 (WAGO I/O SYSTEM)/Montieren/Demontieren/I/O-Modul einfügen (neutrales 3D) @ 35\mod_1561382037253_21.docx @ 548869 @ 3 @ 1
6.2.1
Inserting the I/O Module
1.
Position the I/O module in such a way that the groove and spring are
connected to the preceding and following components.
Figure 11: Inserting I/O Module (Example)
2.
Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.
