42
sympHony
™
Meter User Guide
General Troubleshooting
Problem:
The display freezes and the measurement values will not change.
Solution:
The meter is in the AUTO-READ measurement mode (the AR icon will
appear in the top, right corner of the display). Press
to start a new
measurement or set the meter to the continuous measurement mode
in the setup menu.
Problem:
When I press
the meter displays
.
Solution:
The meter is printing and cannot enter the calibration mode until the
printing is complete. This should rarely occur if the meter is set to
a 9600 baud rate. If the meter is at a lower baud rate, the delay will
be longer.
Problem:
The meter did not accept the change I made in the setup menu.
Solution:
After making a change in the setup menu, press
until the arrow
icon points to the top line (confirms the change) and then press
to
save the change and return to the measurement mode.
Problem:
How do I abort a calibration?
Solution:
Press and hold
to abort any meter operation and return to the
measurement mode.
Problem:
The printout is a string of numbers and units with commas.
Solution:
The output format in the setup menu is set to the computer output.
Change the output format to the printer output in the setup menu.
The printer baud rate is set incorrectly in the setup menu. Change the
baud rate to the correct value for the printer that is being used.
Problem:
When I press the stirrer button, the stirrer doesn’t work.
Solution:
The current stirrer setting is off. Set the speed to 1 through 7 in the
setup menu.
Problem:
The timed reading time entry screen does not appear in the
setup menu.
Solution:
The meter is in the AUTO-READ or continuous mode. When the meter
is set to the timed mode, the next setup screen will be for time entry.
Troubleshooting
Summary of Contents for sympHony
Page 12: ...VWR sympHony Meter User Guide Exhibit 5 2...
Page 69: ...254503 001 Rev B...
