VTEL Galaxy, Installation And Configuration Manual

Page: 48 / 76

Installation and Configuration Guide
Chapter 7. Completing Setup
7.2
Camera(s)
Sony D30/D31 PTZ
Turn the power switch to the ON location. The switch is on the back of the camera.
SmartTrak
From the rear of the SmartTrak unit, verify that:
•
Each camera power switch is in the ON position
•
The left camera is set to Camera 1
•
The right camera is set to Camera 2
Monitors
The power button is located in front of the monitors.
When the monitor is turned on, the screen should display “RGB”
and not “AV1” or “AV2.” If you see either of these, use the Input
Selector on the monitor’s remote control (or on your monitor’s
front panel) to change the setting to “RGB.”
Final Furniture Changes
1. Place the rear door on the primary cabinet and lock it, if desired.
2. Repeat Step 1 for the secondary cabinet if you have a dual monitor system.
3. Close the front doors and lock them.