VTEL Galaxy, Installation And Configuration Manual

Page: 24 / 76

Installation and Configuration Guide
Chapter 4. Adding Peripherals
4.2
VGA Monitor (Optional)
An optional VGA monitor can be ordered as a replacement or substitute for the control monitor.
Audio
All speaker connections were completed in the factory.
Camera(s)
Sony
TM
D30/D31 PTZ Cameras
Mounting on the Monitor
Refer to Figure 4-1 on page 4.3 for the illustration relating to this procedure.
1. Locate the two black camera mounting brackets and separate them. (One mounting bracket is labeled
Camera . The Monitor bracket is not labeled.)
2. Attach the Camera mounting bracket to the bottom of the camera by inserting the flathead screw
through the large countersunk hole. Orient the bracket so that the curved side is toward the front and
the word
Camera is visible from the bottom of the mounting bracket.
3. Orient the other bracket (the Monitor bracket) so that the studs face up. Engage the front stud into the
V-slot of the camera bracket.
4. Slide the bracket forward until the two threaded studs at the rear of the plates engage the clearance holes
in the camera bracket.
5. Use the two knurled nuts to secure the mounting bracket to the camera assembly.
6. Add the wedge to the bottom of the bracket assembly by removing the adhesive backing from the
assembly. Align the curved edges and press together.
7. Make sure the mounting area is free from dust, oils, or any other material or chemicals that might
prevent proper adhesion. Then, place the entire camera mounting assembly on top of the monitor in the
position you want. Mark the monitor to indicate the location of the mounting bracket.
8. Remove the paper liner from the bottom of the wedge.