VTEL Galaxy, Installation And Configuration Manual, Page: 15 / 76

Installing the Secondary Cabinet
2.5
Galaxy
TM
3. Locate the jack stand in the peripherals box and place it under the front right leg of the primary system
(Figure 2-6).
Figure 2-6 Jack Stand in the Peripherals Box
4. Remove the two screws securing the front right caster arm to the primary cabinet. Have your assistant
steady the furniture
before removing the arm.
An Allen wrench is included in the Joiner Kit to assist in the removal of these screws.
5. Connect the secondary frame to the primary frame by sliding the Y-shaped caster over the primary leg.
6. Loosely replace the screws that were removed in step five.
Do not fully tighten the screws at this time.
7. Remove the jack stand.
Rear Crossbar
1. Remove the outer C-shaped gray cable extrusions from the rear inside legs of the primary and secondary
furniture.
Sketch or write down their placement, as you must re-attach them later.
The larger H-shaped extrusions can remain in place.
secondary
cabinet
primary cabinet
original caster from primary cabinet
(removed)
jack stand
Y-shaped caster