APS787Z_RevD_07/20
3
Detailed Descriptions:
Wire Harness Colors and Func�ons
Alarm / Notification Connector (4-pin connector)
See page 33 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
2. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Verification for default setting:
•
If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
•
If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
Note:
This wire can be programmed to perform the
Trunk Release Output
func�on by changing its op�ons.
Refer to
Bank 2, Feature 14
on page 9.
1. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default setting, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connec�on of the relay input (WHITE/RED wire).
Verification:
The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
Note:
This wire can be programmed to perform the
Trunk Release Output
func�on by changing its op�ons.
Refer to
Bank 2, Feature 14
on page 9.
4. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Verification:
The vehicle ground (-) source wire registers ground (-) at all �mes.
Note:
Before making this connec�on, remove all module fuses un�l the system is completely connected.
3. WHITE/BLACK – Siren Output (+)
The WHITE/BLACK wire supplies 12-Volt (+) to power the siren. A�er moun�ng the siren, connect its BLACK wire to a
reliable ground source, and connect the WHITE/BLACK wire to the siren’s RED wire.
1
3
2
4
8. BLUE – Ignition 1 Input / Output (+)
The BLUE wire supplies 12-Volt (+) to the vehicle’s primary igni�on wire during remote start. This wire is also used to
sense vehicle igni�on for the Programming Func�ons
Verification:
The primary igni�on wire registers 12-Volt (+) when the vehicle is in igni�on mode AND during engine crank.
7. PURPLE – Accessory Output (+)
At its default setting, the Purple wire supplies 12-Volt (+) to the vehicle’s accessory wire to power vehicle accessories
during remote start.
Verification:
The accessory wire registers 12-Volt (+) when the vehicle is running or in accessory mode, but not during
engine crank or if the vehicle is off.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 9
on page 13
.
Power Connector (8-pin High-Current Connector) (Cont)
See page 33 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
