APS787Z_RevD_07/20
25
Quick Reference:
Programming & Diagnos�cs
Tach Function
When using the GREEN/ORANGE tach wire, the vehicle tach rate must be programmed.
Programming with valet button when tach wire is connected:
1. Turn the igni�on key to the ON posi�on.
2. Press and release the valet bu�on three (3) �mes.
3. Immediately turn the igni�on key OFF.
4. Press and hold the valet bu�on, then start the vehicle using the key.
5. When the unit senses the tach signal, the parking lights will begin to flash.
6. Allow the vehicle to se�le to a normal idle speed.
7. Release the valet bu�on.
The parking lights will turn on for two (2) seconds and one (1) long chip will indicate that the learned tach signal is stored
and the unit has exited tach learn mode.
Programming without valet button when tach wire is connected:
1. Turn the igni�on key to the ON posi�on and start the vehicle's engine.
2. Wait for Engine RPM to lower to a normal idle.
3. Press and hold the vehicle's brake pedal.
4. Press the LOCK bu�on on the OEM remote or the Carlink App.
The vehicle's parking lights will flash seven (7) �mes to indicate the tach signal has been learned. If the parking lights do
not flash, locate another tach source and repeat steps 1 - 4 above.
Note: Programming tach signal via OEM or Telema�cs control is only available on Firmware v1.47 or Higher.
Data Port Protocol Selection
The default data port protocol of this model is ADS (iDatalink 2-Way). This model is capable of detec�ng the correct
data port protocol (ADS or DBI) and automa�cally configuring Feature Bank 2; Feature 18. To ini�alize the detec�on
procedure:
1. Press and hold the valet bu�on.
2. Cycle the vehicle’s Igni�on ON/OFF two (2) �mes.
3. Release the valet bu�on.
Note
: This feature is only available on module firmware v2.0 or higher.
Dome Light Delay
To program the Prestige system to wait until the dome light turns off before arming:
1. Close all doors.
2. With the vehicle igni�on off, press LOCK, UNLOCK, LOCK ,UNLOCK, LOCK, UNLOCK, LOCK on the remote control. The
dash-mounted LED will turn on.
2. Immediately OPEN then CLOSE the door WITHOUT disarming the system. A�er the dome light turns off, the LED will
flash to indicate programming comple�on.
3. Disarm and exit the vehicle.
To return the system to default dome light sensing:
1. Turn the vehicle igni�on ON then OFF three (3) �mes, then press and hold the valet bu�on for five (5) seconds.
2. The system will beep one (1) �me indica�ng the learned delay has been cleared.
