APS787Z_RevD_07/20
23
2
= Bank 2
3
= Bank 3
Ignition On
Ignition Off
Press and Release
Override Button
1 Chirp = Bank 1
(Program Remotes)
Cycle Key to Advance
Banks (2,3)
Chirps Indicate
Bank Number
Chirps Indicate
Option Number
Press Override Button to
Advance Within Bank
Repeat Steps to Program
Another Feature Bank...
... or Exit
Programming
Press to Change
Feature Option
LED Indicates
Feature Selection
3X
Note:
Programming will time out after 60sec with no activity or Ignition Off for 5sec.
1X
Repeat Steps to Program
Another Feature ...
LO
C
K
AC
C ON ST
A
R
T
LO
C
K
AC
C ON ST
A
R
T
LO
C
K
AC
C ON ST
A
R
T
Once the system is installed and powered up, you will use the vehicle igni�on, override bu�on and a programmed
remote control to set all system op�ons. Feature op�ons are divided into categories, or
Banks
, as described throughout
this sec�on.
Ensure that at least one remote control is programmed
to the system. If not, or if you need to program
more remote controls, use the diagram steps to access
Bank 1.
The siren and LED will indicate your status and selec�ons. Follow the diagram below to enter and maneuver through the
programming procedure.
Quick Reference:
System Programming
Programming Mode Entry and Exit Procedure
1. Turn the igni�on ON.
2. Press and release the valet bu�on three (3) �mes.
3. The system will beep one (1) �me, indica�ng you have accessed Bank 1.
4. Each cycle of the Igni�on, OFF/ON, will advance to the next bank (up to Bank 3) then restart at Bank 2. (Note: To re-
access Bank 1 for transmi�er programming, you will need to exit and re-enter programming mode.)
5. The system will beep a number of �mes to indicate the Bank number:
•
1 beeps:
Bank 1 - Programming Remote Controls
•
2 beeps:
Bank 2 - Security Control Options
•
3 beeps:
Bank 3 - Remote Start Control Options
6. Once you have accessed the desired bank, press the valet bu�on to advance though the features. The LED will flash a
number of �mes to indicate the feature, based on the charts that follow this sec�on. The system will chip a number
of �mes to indicate the Op�on programmed.
7. Once you have accessed the desired feature, press the LOCK bu�on on the remote control to advance though the
feature's setting op�ons. The system will beep a number of �mes to indicate the Op�on setting, based on the charts
that follow this sec�on.
8. Once you have made the desired setting, you can press the valet bu�on to advance through the
features within the bank, or cycle the Igni�on key OFF/ON to advance to the next bank.
9. Once you have completed programming,
you MUST turn the ignition key to OFF
to exit the programming
mode. Programming will automa�cally exit a�er sixty (60) seconds of inac�vity.
