APS787Z_RevD_07/20
14
Remote Start Control (Bank 3) (cont.)
See page 23 for Programming Instruc�on.
Detailed Descriptions:
Setup Op�ons
Feature 11:
Maximum
Crank Time
Func�on:
Set maximum crank time for all remote start settings.
Setting Choices:
• Option 1 -
Starter will crank for
.8
second
s.
• Option 2 -
Starter will crank for
1
second
.
• Option 3 -
Starter will crank for
1.5
seconds
.
• Option 4 -
Starter will crank for
2
seconds
.
• Option 5 -
Starter will crank for
4
seconds
.
Feature 6:
Start Sensing Voltage Level
Func�on:
Set the sensitivity of voltage variance measurement to determine if the vehicle has started when Feature 5 is
set to option 2, Voltage.
Setting Choices:
• Option 1 - High:
Voltage difference before remote start and a�er must be greater than .5 volts.
• Option 2 - Low:
Voltage difference before remote start and a�er must be less than .5 volts.
Feature 5:
Engine Confirmation Mode
Func�on:
Determine how the system knows if remote start was successful.
Setting Choices:
• Option 1 -
Determined by
measurement
from the
Purple/White
Tach Input wire.
• Option 2 -
Determined by the
voltage difference
before remote start and a�er as set in
Bank 3, Feature 6
.
• Option 3 -
Receives informa�on through an a�ached
data bus interface
.
• Option 4 - No sensing
; assumes vehicle has started based on setting in
Bank 3, Features 11 & 14
.
Feature 9:
Accessory Output Function (Purple)
Func�on:
Set the functionality of the programmable Accessory output.
Setting Choices:
• Option 1 -
Wire sends 12-Volt (+) during igni�on;
drops out
during start.
• Option 2 -
Wire sends 12-Volt (+) during igni�on
and start.
• Option 3 -
Wire sends 12-Volt (+) during start
only.
Feature 7:
Ignition 2 Output Function (Green)
Func�on:
Set the functionality of the programmable Ignition 2 output.
Setting Choices:
• Option 1 -
Wire sends 12-Volt (+) during igni�on
and start.
• Option 2 -
Wire sends 12-Volt (+) during igni�on;
drops out during start
.
• Option 3 -
Wire sends 12-Volt (+) during start
only
.
Feature 8:
Ignition 3 Output Function (Pink)
Func�on:
Set the functionality of the programmable Ignition 3 output.
Setting Choices:
• Option 1 -
Wire sends 12-Volt (+) during igni�on
and start.
• Option 2 -
Wire sends 12-Volt (+) during igni�on;
drops out during start
.
• Option 3 -
Wire sends 12-Volt (+) during start
only
.
Feature 10:
Transmission Type
Func�on:
Set the functionality of the remote start system based on the vehicle transmission type.
Setting Choices:
• Option 1 -
System is set for
Automatic
transmission.
• Option 2 -
System is set for
Manual
Transmission. (
Note:
Remote Start Ready Mode must be set by the driver
before exi�ng the vehicle.)
