APS787Z_RevD_07/20
2
Detailed Descriptions:
Wire Harness Colors and Func�ons
Power Connector (8-pin High-Current Connector)
See page 33 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
3. YELLOW – Starter Output for Remote Start (+)
The YELLOW wire supplies 12-Volt (+) to the vehicle’s starter wire when remote start is enabled, and turns off once the
vehicle is started.
Verification:
This starter wire registers 12-Volt (+) during engine crank.
Note:
If installing a starter kill relay in addi�on to remote start, connect the YELLOW wire to the MOTOR SIDE of the cut
starter wire.
Refer to Start Kill diagram on page 32.
5. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Verification:
The power wire registers 12-Volt (+) at all �mes.
Note:
Before making this connec�on, remove all module fuses un�l the system is completely connected.
4. GREEN – Ignition 2 Output (+)
At its default setting, the GREEN wire supplies 12-Volt (+) to the vehicle’s secondary igni�on wire during remote start.
Verification:
If present, the secondary igni�on wire registers 12-Volt (+) when the vehicle is in igni�on mode AND during
engine crank.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 7
on page 13.
6. RED/WHITE – 12-Volt Input (+)
The RED/WHITE wire connects to the vehicle’s secondary 12-Volt (+) wire to power the remote start func�on.
Verification:
The power wire registers 12-Volt (+) at all �mes.
Note: Before making this connec�on, remove all module fuses un�l the system is completely connected.
1
3
5
7
2
4
6
8
1. RED/BLACK – Ignition 3, Flex Relay Input (Internal Relay Pin 87)
The RED/BLACK wire is used to supply the Pin 2 - PINK Flex Relay Output. This wire can be connected to 12-Volt (+) or
Ground (-). Please check vehicle requirements for correct polarity.
Note: Before making this connec�on, remove all module fuses un�l the system is completely connected.
2. PINK – Ignition 3 Flex Relay Output (Internal Relay Pin 30)
At its default setting, the PINK wire supplies 12-Volt (+) or Ground (-) to the vehicle’s secondary igni�on wire during
remote start. The polarity of this output is provided by the Pin 1, RED/BLACK Input.
Verification:
If present, the secondary igni�on wire registers 12-Volt (+) or Ground (-) when the vehicle is in igni�on mode
AND during engine crank.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 8
on page 13.
