Settings
First read and observe the introductoryinformation and safety warnings
⇒
Introduction
Depending on the vehicle equipment, settings for Park Distance Control can be made in the
Infotainment system
⇒
Operation and display in the Infotainment system
.
You can save some settings in the user accounts of the personalisation function. The settings
change automatically when the user account is changed
⇒
Personalisation
.
Troubleshooting
First read and observe the introductoryinformation and safety warnings
⇒
Introduction
No sensor visibility, error message, system switches itself off
The sensor area is switched off permanently if a sensor fails.
Any malfunctions in the Park Distance Control system will be indicated by a text message and a
warning tone when first switched on, and by the indicator lamp flashing in the
or
buttons. If the sensors are dirty or covered, the affected sensor cluster will be displayed on the Park
Distance Control screen. A cleaning message (depending on equipment) will also be displayed.
• Clean the sensors or remove stickers or accessories from the sensors and cameras
⇒
Caring
for and cleaning the vehicle exterior
.
• Check whether any damage is visible.
The system is not responding as expected
• The sensors are dirty
⇒
Caring for and cleaning the vehicle exterior
. The sensor visibility may
be impaired by dirt and snow or also residue from cleaning agents or coatings.
• The system requirements must be met
⇒
System limits
.
• The sensors are covered by water.
• The factory-fitted towing bracket is electrically connected with the trailer
⇒
Trailer towing
.
• The vehicle is damaged in the area of the sensors, e.g. caused by parking collisions.
• The detection ranges of the sensors are blocked by add-on parts, e.g. bicycle carriers.
• Changes have been made to the paintwork in the area of the sensors or structural modifications
have been made, e.g. on the vehicle front end or the running gear.
• The ultrasound signal is subject to interference from external noise sources, e.g. rough tarmac
surface or cobblestones.
Response to all circumstances
• Switch off the system temporarily.
• Check whether any of the causes described below apply.
• You can switch the system back on again once you have rectified the cause of the problem.
• If the system still fails to respond as expected, have the system checked by a qualified
workshop.
Rear view camera system (Rear View)
Introduction
This chapter contains information on the followingsubjects:
⇒
Switching on and off
⇒
Display representation
⇒
Prerequisites
⇒
Parking perpendicular to the road (mode 1)
⇒
Parking parallel to the road (mode 2)
⇒
Troubleshooting
The rear view camera system in the
rear of the vehicle makes it easier for
the driver to see behind the vehicle and
provides support for parking
manoeuvres.
The rear view camera system shows the area behind the vehicle on the Infotainment system
screen. Depending on the operating mode, orientation lines support the view to the rear.
Modes for the rear view camera system
Depending on the vehicle equipment, the following operating modes are available:
