Check to see if a fuse has blown Changing fuses.
Follow the instructions to change the affected bulb . Always use identical bulbs with the
same designation. The designation is inscribed on the bulb, either on the glass part or on
the base.
Do not touch the glass part of the bulb with unprotected fingers. The heat of the bulb would
cause the fingerprint to evaporate and condense on the reflector. This will impair the
brightness of the headlight.
After changing the bulb, check to ensure that the bulb is working properly. If the bulb is not
working properly, the bulb may not have been inserted properly or may have failed again,
or the connector may have been inserted incorrectly.
Any time you change a bulb in the front of the vehicle, the headlight settings should be
checked by a qualified workshop.
Changing bulbs in the headlights (halogen bulbs)
Fig. 204
In the engine compartment: covers and bulbs on the left front headlight.
First read and observe the introductoryinformation and safety warnings
⇒
Introduction
The front headlight does not need to be removed when changing bulbs.
The actions should only be carried out in the specified order:
⇒
Fig. 204
Dipped beam
headlights
Side
lights/daytime
running lights
Turn signal
Main beam
headlights
1.
Observe and follow the instructions on the checklist
⇒
Checklist Information on
changing bulbs
.
2.
Open the bonnet
⇒
In the engine compartment
.
3.
Pull off the rubber
cover
①
from
the back of the
headlight.
Pull off the rubber
cover
①
from
the back of the
headlight.
Pull off the rubber
cover
②
from
the back of the
headlight.
4.
Turn the bulb
holder
③
anticlockwise as
far as it will go and
pull it out to the
rear along with the
bulb.
Turn the bulb
holder
④
anticlockwise as
far as it will go and
pull it out to the
rear along with the
bulb.
Turn the bulb
holder
⑤
anticlockwise as far
as it will go and pull
it out to the rear
along with the bulb.
Turn the bulb holder
⑥
anticlockwise
as far as it will go
and pull it out to the
rear along with the
bulb.
5.
If applicable, push the catch on the bulb holder and pull the bulb straight out of the
bulb holder.
6.
Replace the defective bulb with a new bulb of the same type.
7.
Ignoring any of the items on this important safety checklist can lead to accidents and
severe injuries.
• Always follow the instructions in the checklist and observe the general safety
procedures.
WARNING
Always take care when removing or fitting lights to prevent damage to the paintwork or to
other vehicle parts.
NOTICE
