Progress bar. Symbolically shows the relative distance still to be driven.
Direction indicator for next manoeuvre for driving out of the parking space.
Park Assist can drive out of parallel parking spaces.
Requirements for driving out of a parking space while using Park Assist must be fulfilled
⇒
Prerequisites
.
• Press the
button.
• Use the turn signal and main beam lever to select the direction (left or right) in which you would
like to drive out of the parking space.
• Select reverse gear.
• Release the steering wheel when the following message is shown:
Steer. intervention active.
Check area around veh.!
• Carefully press the accelerator.
• Brake when an acoustic signal sounds, the white symbol
lights up or when the prompt to
drive forwards appears on the instrument cluster display.
• Depress the brake pedal until Park Assist steering activity has been completed or until the white
symbol
disappears on the instrument cluster display.
• Repeat reversing and driving forwards until a corresponding message is displayed on the
instrument cluster. A signal tone may also sound.
• Take over steering with the steering angle set by Park Assist.
• Drive the vehicle out of the parking space when permitted by the traffic situation.
Troubleshooting
First read and observe the introductoryinformation and safety warnings
⇒
Introduction
No sensor visibility, error message, system switches itself off
Park Assist is switched off if a sensor fails.
• Clean the sensors or remove stickers or accessories from the sensors and cameras
⇒
Caring
for and cleaning the vehicle exterior
.
• Check whether any damage is visible.
The system is not responding as expected
• The sensors are dirty
⇒
Caring for and cleaning the vehicle exterior
. The sensor visibility may
be impaired by dirt and snow or also residue from cleaning agents or coatings.
• The system requirements must be met
⇒
Prerequisites
.
• The sensors are covered by water.
• Park Assist cannot be switched on if the factory-fitted towing bracket is electrically connected to
the trailer. For vehicles with the trailer manoeuvring system, this function is switched on when
the
button is operated
⇒
Trailer towing
.
• The vehicle is damaged in the area of the sensors, e.g. caused by parking collisions.
• The detection ranges of the sensors are blocked by add-on parts, e.g. bicycle carriers.
• Changes have been made to the paintwork in the area of the sensors or structural modifications
have been made, e.g. on the vehicle front end or the running gear.
• The ultrasound signal is subject to interference from external noise sources, e.g. rough tarmac
surface or cobblestones.
Response to all circumstances
• Switch off the system temporarily.
• Check whether any of the causes described below apply.
• You can switch the system back on again once you have rectified the cause of the problem.
• If the system still fails to respond as expected, have the system checked by a qualified
workshop.
Area View
Introduction
This chapter contains information on the followingsubjects:
⇒
Prerequisites
⇒
Switching on and off
⇒
Display representation
⇒
Operating camera views
⇒
Troubleshooting
Area View provides you with an
overview of the area around the vehicle
