VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
76
Connecting the “in cab” wiring
☐
Unplug the OEM cable from the accelerator pedal and plug it into the matching
connector from the throttle control box. Plug the cable from the throttle control
into the matching connector on the accelerator pedal.
☐
Connect the red wire from the throttle controller to the interface cable clutch
wire connector.
☐
Connect the green wires from the interface connector and the throttle control
to the OEM ground located on the dashboard support.
☐
Remove the glove box compartment to gain access to the wire run behind it
(Figure 116).
Figure 116 — SEIC pass through
☐
Run the wires from the throttle control to the SEIC behind the glove box and
secure with cable ties.
☐
Unplug the SEIC pigtail from the SEIC interface plug.
☐
Connect the red wire with butt connector from the interface connector to the
green wire with orange stripe (CBP22).
☐
Solder and seal the black wire from the interface connector to the white wire
with violet stripe (CMC25).
☐
Solder and seal the white wire from the throttle control to the blue wire
(CE913).
☐
Solder and seal the blue wire from the throttle control to the grey wire with
brown stripe (CET22).
