Page 28
HDT-1000 User and Technical Manual
HDT-1000 Screen:
Network Configuration
Screen
Menu Path:
System
>
Network Setup
NOTE:
You may be logged out of the Web Browser Control Interface if changes are made on
the Network Configuration Screen.
NOTE:
In the event that you have forgotten or lost network configuration of the HDT-1000, the
network settings can be set back to the default static IP of 192.168.1.200 by simultaneously
holding down the up, down, and audio 1 keys on the top of the radio for 8 seconds until the
lights on the interface flash. This indicates that the IP has successfully been reset to default
settings.
Hostname
[Hostname
Section]
To customize the transmitter’s
Hostname
, enter a name, then click the
Apply
Button to set [below]. Default = Vislink
DHCP
[Network Interface
ETH0 Setion]
Select
Enabled
or
Disabled
to select the
Dynamic Host Configuration
Protocol
status, then click the
Apply
Button [below] to set. How you would
use this is dependent on your application. Normal = Disabled [Static IP
Address]
IP Address
[Network
Interface ETH0 Setion]
Enter the
Internet Protocol Address
. The default is
192.168.1.200
.
Subnet Mask
[Network
Interface ETH0 Setion]
Enter the
Subnet Mask
. The default is
255.255.0.0
.
Default Gateway
[Network
Interface ETH0 Setion]
Enter the
Default Gateway
address such as
192.168.1.1
.
Name Server
[Network
Interface ETH0 Setion]
Enter the address of your
DNS
server such as 8.8.8.8. The
Domain Name
Server
translates host names meaningful to humans into Internet Addresses.
MAC Address
[Network
Interface ETH0 Setion]
Read Only: The hexadecimal
MAC Address
for the
Network Interface
Card
in your transmitter, such as
AA:12:BB:34:CC:56
.
Apply
Click the
Apply
Button to set the changes to your transmitter. [See the note
above.]