18
11. OPERATION
Once the chronothermostat has been programmed, it can be put into operation�
If the relay is activated, the symbol is displayed in the winter (heating) or the
symbol in the summer
(air-conditioning)�
• Setting manual operation
- Repeatedly press button
until the display shows the symbol
MAn
alongside the blinking value of the temperature�
- Use button
to select the desired temperature value then press button
to confirm or button
to cancel
the operation� If the setting is not confirmed within approximately 40 seconds, the chronothermostat will return to the
previously set operating mode�
- After selecting
“Manual”
mode
it is possible to change the set temperature value with button
; this change will
be confirmed automatically after approximately 5 seconds�
-
From any operating mode it is possible to move onto
“Manual” operation
by pressing button
� This operation
differs from the above only in the fact that, on pressing button
again, you return to the previously set operating
mode�
• Setting timed manual operation
- Repeatedly press button
until the display shows the symbol
MAn
alongside the blinking value of the temperature�
- Press button
; the display will show two blinking digits indicating the number of hours (h) to set�
- Use button
to select the desired number of hours (from 1 to 99) then press button
to confirm�
The chronothermostat display shows the phase of setting the number of hours with the following indications:
- if the set number of hours is included in the current day, the chronothermostat shows the time when the
“Timed
Manual”
setting ends with two segments blinking on the time printed under the display;
- If the set number of hours exceeds those of the current day (therefore moving on to the next days), the
chronothermostat will show not only the time when the
“Timed Manual”
setting ends (see above), but also the day
when this setting ends; the
arrow will be shown blinking on the day printed above the display�
