Optional Independent Support
If it is necessary to provide independent support for the SurveyorVFT, other than the ceiling material, order
the optional In-Ceiling Model Mount Kit SVFT-IC-KT. It consists of a pre-assembled set of mounting rails and
folding ring, as shown in Figure 9.
1. With the 7-3/8-inch (187 mm)
diameter hole cut in the
ceiling tile and tile replaced in
the ceiling, push the folded
assembly up through the hole
and unfold.
Figure 9
Optional In-Ceiling Model Mount Kit Installation
2.
Position the assembly
squarely over the hole and
fasten the caddy rail clips to
the existing frame. Remove
adjacent tiles to access the
clips.
3. Adjust the position of the
caddy rail clips along the
frame to obtain the best “X”
position.
4. Slide the assembly along the
caddy rails to obtain the best
concentric “Y” position.
Tighten the horizontal
adjustment screws to secure
the position.
Figure 10
Optional In-Ceiling Model Mount Kit Installation Ring Location
5. With the ring concentric with
the hole, slide the ring
vertically along the support
slots to obtain the best flush fit
in the ceiling. The ring should
be firmly seated against the
tile without warping the tile, as
shown in Figure 10.
6.
Finally, complete the
installation as described in the
procedure of the previous
sub-sections. In this
installation, the flippers will
secure the enclosure to the
mounting ring assembly
instead of the tile.
18
•
4BInstallation
XX134-07-00 Rev 908 SurveyorVFT Camera Dome System
Summary of Contents for SVFT-C22
