Vicon SVFT-C22, Installation And Operation Manual

Page: 58 / 80

50
•
8BOperation XX134-07-00 Rev 908 SurveyorVFT Camera Dome System
Operation
Following the complete installation and setup of the SurveyorVFT, it is necessary to perform initial power-up
testing and verify proper operation. If the SurveyorVFT fails to power-up correctly, go to the Troubleshooting
sub-section of this section. When initial power-up has been completed and verified, SurveyorVFT can be
setup and operated in a normal fashion using a Vicon remote
through a PC running the Surveyor Direct Control pro
workstation.
Initial Power-Up
and
verify that no signal is displayed.
and configured in
(Figure 26)
If any test
s to the
of the current DIP switch
proper operation. (Note: Figure 27 is
only a sample screen.)
NOTE: The camera drive always returns to
operator keypad, VPS/NOVA/Pilot unit or
i gram; the V conNet can be run from a ViconNet
1. Setup an appropriate monitor within
the vicinity of the SurveyorVFT.
Connect the video out cable to the
monitor. Power-on the monitor
2. Verify that the SurveyorVFT has been
installed, wired
accordance with this manual.
3. Switch the AC power on to the
SurveyorVFT. The monitor will display
the power-up test screen
for the duration of its initial testing. This
test displays the status of the functions
pan, tilt, zoom, focus and the integrity
of the memory (NVRAM).
fails, “FAIL” displays in place of
“PASS.”
The SurveyorVFT then switche 4.
opening screen (Figure 27). This
screen will display the camera dome
program version, current date/time and
some
settings. Upon completion of homing,
the SurveyorVFT is ready to verify
the pan and tilt coordinates it was
initially powered-up with unless
autohome on power-up was set.
Figure 26
Power-Up Test Screen
Figure 27
Opening Screen