Vicon SVFT-C22, Installation And Operation Manual

Page: 60 / 80

52
•
8BOperation XX134-07-00 Rev 908 SurveyorVFT Camera Dome System
2. Press the PP ENTER key; the PRESET LED displays a blinking 0.
. Press the PP ENTER key again. The PRESET LED display remains with the number 95. The monitor will
5. The SurveyorVFT then switches to the opening screen (Figure 27). This screen will display the camera
dome program version, current date/time, the curr
baud detect. Move the joystick or press buttons to send commands and commence auto-baud detect.
Troubleshooting
3. Press the 9 and 5 numeric keys in that order.
4
display the power-up test screen (Figure 26) for the duration of its initial testing.
ent address and a request to send communications to
If the SurveyorVFT does not power-up correctly, chec
⇒
Check if the power LED DP2 on the Customer Interface Board is on. If the voltage is too low, the LED will
stay off.
⇒
Verify, with a voltmeter, that 18 to 32 VAC is mea
integrity of the power wiring. If less than 18 VAC is m
too long. Check the maximum usable cable distance
Technical Information section. If 18 to 32 VAC is measured, return the SurveyorVFT back to factory for
service in accordance with the Shipping Instructio
⇒
If the last screen displays and does not disappear,
control device. Verify that the SurveyorVFT address is selected on the control device. Sometimes moving
the joystick can begin communicati
established, check the integrity of the
pendently, it is possible that the
ment of the control and response
or Half Duplex in a Half Duplex wired
⇒
If the SurveyorVFT powers up but does not display an
cable connection. Verify that BNC connectors are atta
addition, verify that the cable is not damaged. It is com
somewhere along its run. If possible, check the outpu
camera dome site.
k the following:
sured across TB1, pins 1 and 2. If not, check the
easured, it is probable that the power cable length is
for the voltage input as stated in Table of the
ns section of this manual.
the SurveyorVFT is not communicating with the
on. If communication cannot be
control signal wiring. If all wiring is correct, swap the camera drive and re-check. If the new camera drive
communicates, return the SurveyorVFT back to the factory for service in accordance with the Shipping
tr anual. Ins uctions section of this m
⇒
If the SurveyorVFT is intermittently operational or operating inde
eck proper place communications (control) wiring is incorrect. Re-ch
signals on the terminal block. Also, verify that SW2, switch 3 is set f
SurveyorVFT.
y video, it is possible that there is a poor video
ched at the camera dome and monitor/CPU. In
mon for the cable to be stretched or squashed
t locally, with a portable monitor, at the actual