Vicon SVFT-C22, Installation And Operation Manual

Page: 32 / 80

Figure 17
Installing the Safety Cords
14. Push the camera drive
straight up into the
housing until it snaps into
the housing. Do not use
excessive force. In the
event that it does not
snap easily, remove the
SurveyorVFT and verify
proper cabling.
15. Holding the lower dome,
line up the 2 molded tabs
on the lower dome with
the 2 parallel surfaces of
the housing. Push the
lower dome up and verify
that it snaps into place
on both sides. See
Figure 18.
16. Tighten the 4 trim ring
captive screws to hold
the lower dome in place.
Verify proper orientation
of the grommet.
17. Proceed to the Operation
section of this manual.
24
•
4BInstallation XX134-07-00 Rev 908 SurveyorVFT Camera Dome System