Vicon SVFT-C22, Installation And Operation Manual

Page: 63 / 80

XX134-07-00 Rev 908 SurveyorVFT Camera Dome System 9BCompetitive Protocols
•
55
Sensormatic
Function Keypress Function Keypress
Enter Menu
Press and hold IRIS Open, press and hold
Focus (near or far), press Zoom Out Set Transmit
Polarity
Not Supported
Select/Store FF Program Sectors Not Supported
Backup/Abort/Exit Close Reset Dome
Press Menu. Using the trackball scroll to
"Reset Dome", press Zoom
Iris Open Open - Controls Manual Iris Levels Set AP limits Not Supported
Iris Close Close - Controls Manual Iris Levels Set Pan limits Not Supported
Focus Near
Focus Near (Button to right top of track
ball)
Diagnostic Screen Not Supported
Focus Far
Focus Near (Button to right bottom of track
ball)
Debug Screen Not Supported
Zoom Out
Zoom Out (Button to right bottom of track
ball)
Preset Tours
Internal dome tours are programmed using
the menu system. To run a tour enter 80-87
and press "View ". The AD keypad also
supports programming tours that are stored
in the AD keypad. The dome w ill respond to
these tours. To program the AD keypad
tours press Menu. Use the trackball to scroll
to Define Sequence, press Focus or Zoom to
enter. Now use the trackball to program
sequence.
Zoom In
Focus Near (Button to right top of track
ball)
Auto Tour
Tw o Patterns mapped to our preset 88 and
89. Patterns can be stored through the menu
system or through the keypad. To program
through the keypad press menu, use the
trackball to scroll to Record Pattern, press
Focus or Zoom to select, enter number of
pattern to program. Move the dome to record
the desired pattern. Press Next to store. To
run pattern select 1 for autotour 88 and 2 for
autotour 89. Press Pattern to run once or
Repeat Pattern to repeat.
Camera Off Not Supported Night Mode- Manual Not Supported
Camera On Not Supported Alarms
Vicon Menu Alarms are not used. Alarms are
alw ays enabled. The dome w ill report to the
AD keypad w hich alarm is activated (1-4)
and the AD keypad controls alarm action.
Autopan Not Supported
Alarm
Acknow ledge
Alarm titles are disabled. The protocol does
not support an alarm acknow ledge
command. The AD keypad does respond to
the dome alarm.
Autoiris
Press Open or Close to put Iris in manual
mode. Press Close and Open together to
return to Autoiris. Turbo (Set speed
to full) - (Pelco
Feature)
Not Supported
Lens Speed Not Supported
Flip (Turn 180
degrees)
Press Flip
Auxs
Supports only a latching relay. Press <1>
Output On to engage - Press <1> Output
Off to disengage
Peel (Sensormatic
Feature)
Not Supported
Presets
Presets 1-79 - To store a preset - Press
Menu. Using the trackball scroll through the
keypad menu to "Setup View ", press
Focus or Zoom to select, enter preset
number, press Focus or Zoom to select. To
recall a preset enter the preset number and
press View .
Camera Control
Including Adjust
V-Phase
Menu system
Pan and Tilt
Lockout
Not Supported