9. Connect the enclosure’s safety cord clip to the tab in the camera drive to allow the drive to hang from the
enclosure. Refer to Figure 7 for location of tab. Insert the clip of the safety cord on the lower dome into
the hole in the enclosure. Refer to label in the enclosure.
10. Align the 2 slots on the camera drive with the tabs in the enclosure, being sure to match up the arrows on
both the drive and in the enclosure. Insert the camera drive into the enclosure until it snaps into place.
Figure 7
Safety Cord Installation
11.
Lift the lower dome up to the
SurveyorVFT and line up the 2 molded
tabs on the lower dome with the 2
recesses on the inner enclosure. Refer
to Figure 8. There are only 2 ways to
align it.
12.
Push the lower dome up into the
SurveyorVFT. Verify that it snaps into
place on both sides. The upper edge of
the lower dome should be flush with
ceiling plane.
13. Proceed to the Operation section of this
manual.
Figure 8
Final Assembly, Ceiling Mount Version
XX134-07-00 Rev 908 SurveyorVFT Camera Dome System
4BInstallation
•
17
Summary of Contents for SVFT-C22
