Vicon SVFT-C22, Installation And Operation Manual

Page: 75 / 80

XX134-07-00 Rev 908 SurveyorVFT Camera Dome System 13BTechnical Information
•
67
Real time clock allows scheduling of
s, including presets,
urs or autotours (not
on 22X).
tion
age
freeze during preset solve; flip
(invert) video image.
up to 64 event
relays, alarms, to
English, Spanish, French, German
and Italian.
6 programmable motion detec
zones with 3 sensitivity levels; im
Auto baud detection in RS-422/ RS-
485 mode; 4800, 9600, 19,200 bps
baud rates supported.
Available in RS-422/RS-485 mode.
Pan/tilt: 0.125°; zoom: 0.125X.
Surveyor Direct Control program runs
on a standard PC type computer with
an RS422/485 half duplex protocol
interface.
Vicon: RS-422 or RS-485 protocol.
Communication is simplex or hal
DIP switch selectable. (Not available
on ViconNet version.)
Vicon: Vicon’s Pilot and NOVA
Control Systems and V1300X-RVC
desk-top keypad or V1300X-RVC
rack-mounted keypad; NTCIP 1103
compatible hardware.
f
duplex operation at 4800, 9600 or
19,200 baud or Vicon’s enhanced
VicoaxII protocol (superimposed data
gnal) on composite video si
automatically detected upon power
up.
RS-485 protocol utilizes full tri-state
outputs for daisy chain capability.
Pelco: Pelco D Protocol (3/2/99); RS-
communication protocols user’s
guide Rev. A (csd 05/00); RS-
422/RS-485
bps.
May require RS-422 converter,
RCSN422.
Ultrak: KD6, KD6
rotocols;
RS-485 simplex E.8.1, 9600 bps.
Philips: Receiver
o Dome
control code proto
Kalatel: Non-repeating transm
comman
22
00
485 N.8.1, simplex 2400 bps, duplex
4800 bps.
Sensormatic/AD: RS-422/RS-485
duplex N.8.1 4800
-Z control p
/Driver/Aut
col;
RS-232 simplex N.8.1, 2400 or 9600
bps.
it
ds; RS-422 simplex N.8.1,
s. 9600 bp
Cohu: MPC System RS-4
interface; RS-422 duplex N.8.1, 96
bps.
Panasonic: Panasonic conventional
and new camera protocol
NTCIP: 1103 protocol compatible
Scheduling:
Day/Night (2
Control Protocol
Software:
Control Protocol
Format (selectable via
DIP switch 2; see Note on
Competitive Protocols):
Video Out:
Coax: BNC-F.
UTP: 3-position removable screw
Relay Output: 8-position removable
screw terminal block.
Differential Phase: 5º.
SNR: 60 dB.
Data:
h: 850/1300 nm.
Loss Budget (62.5/125 u): 12 dB.
screw terminal block.
ViconNet Digital Video Management
System.
100 Mbps, TCP/IP Unicast.
1, over LAN connection.
1 line-level microphone input, 0 dbm,
32 KHz bandwidth, 600 ohm
impedance,2 V RMS (1 V p-p)
output.
4 in, NO/NC (through SurveyorVFT
in
30 frames per second
(25 fps, PAL), maximum.
streams per camera dome.
480 horizontal TV lines maximum
at 720 x 4
(863 x 586, P
ViconNet ality 1-8,
selectabl bar with 2
compres tings in
resolutio 3 x 586,
, PAL),
360 x
122 (432 x 146, PAL).
1.7 Mbps (per video stream), nom.
Network: Ethernet 100Base-T RJ-45
Multilanguage Menu:
3X) Features:
terminal block.
Control Input/Output:
8-position removable screw terminal
block.
Auto Baud:
Absolute Position Control:
Video:
I/O Level: 1 V p-p.
I/O Impedance: 75 ohms.
Bandwidth: 8 MHz.
Differential Gain: 5%.
Competitive Protocols:
Data Rate: Up to 19.2 Kbps.
Optical:
Wavelengt
Control Protocol
Hardware:
Fiber: Single multimode.
Video Out: ST type.
Control Input/Output: ST type.
Relay Output: 8-position removable
puts); 1 relay out.
NTSC and PAL, model dependant.
1 channel @
Maximum of 10 viewing/recording
88 t pixel palle
AL).
software qu
e on a 4-position
sion level set
ns 720 x 488 (86
20 x 244 (863 x 2 PAL), 7 93
360 x 244 (432 x 293, PAL),
jack. 10/100 Mbps required for
ork connection. netw
Audio: 1/8-in. (3.5 mm) mono jack.
Connector Types:
Fiber Optic Receiver
Communication
Hardware:
LAN Interface:
Number of Video
Channels:
Audio:
s:
Video Streams:
Specs:
Connector Types:
Alarm
Video Formats Supported:
Video Transmission Rate:
Number of Simultaneous
Video Transmission
n:
:
Connector Type:
COAXIAL/UTP VERSION
Resolutio
Video Quality
Video Bandwidth:
S
FIBER-OPTIC VERSION
Note: Pelco is a registered trademark of Pelco. Sensormatic is a registered trademark of Tyco International Limited. Philips/Bosch
is a trademark of Koninklijke Philips Electronics N.V. Kalatel is a trademark of GE Interlogix. Ultrak is a trademark of Honeywell
Inc. Cohu is a trademark of Cohu, Inc.
Panasonic is a registered trademark of Matsushita Electric Industrial Co., Ltd.
VICONNET VERSION
Note: A
this pr
possibi
product with the interfacing equipment. Vicon recommends purchasing a single unit
for bench testing prior to purchasing and installing this product in quantity. ll companies make changes and improvements in their products. Because
oduct can interface with equipment not manufactured by Vicon, there is a
lity that the interface protocols may have changed since Vicon tested this