Viavi OneExpert DSL ONX-580, User Manual

Page: 212 / 282

Chapter 13 Copper Testing
OneExpert DSL User's Guide
22052280, Rev. 015 April 2019 212
NOTE:
In order to convert capacitance (Opens), resistance, and TDR
results to the correct length for your country, make sure your
country and type of cable are selected in the
System Settings / International menu. See Configuring
International Settings on page xx.
Running a OneCheck copper test
The OneCheck Copper test is a Viavi out-of-service pair quality test. It automatically performs
a series of enabled tests including: DVOM (AC/DC volts, resistance), Opens/Capacitance,
Balance, and Load Coil. It also compares results to user-defined threshold values and provides
a pass, marginal, or fail indication. For your convenience, this feature offers two test modes,
with and without UltraFed: OneCheck Good Pair Test and OneCheck with UltraFED IIB
respectively.
1. Connect the tip (A), ring (B), and ground (earth) leads to the line under test. If the test
requires an UltraFED, connect the UltraFED as well.
2. From the OneCheck Copper menu, select OneCheck Good Pair Test , OneCheck with
UltraFED IIB , or any user created profile.
3. If you are adding a new profile or editing an existing profile, you will need to access the
OneCheck Copper Editor application (See OneCheck Copper Editor in the next section ).
Once you are done with editing or creating profiles, press the Save and Launch button
and run the test.
4. To save the report, press the Save Report button. It will open the screen where you can
specify the format of the saved file. Regardless of the format your chose, there will be
also a JSON file saved with the same name. It is accessible on the unit and on StrataSync
after syncing.
The OneCheck Copper test is complete.