Viavi MTS 4000 Base Unit, User Manual

Page: 58 / 254

Chapter 3 Controls of the 4000 Platform
Accessing the 4000 Platform from a PC
36 User Manual 77000000206 Rev. 007
h Click on Ok and close all the dialog boxes opened onto the PC.
3 On the 4000 Base Unit, in the System Setup page, under I/O inter-
face > Ethernet , select Dynamic .
4 Wait for about ten seconds while the connection is established.
Connection via a
local network
1 On the PC : find the IP address and the mask of the PC’s sub-
network:
– With Windows 98 or Millenium: Select Start > Execute , then enter
winipcfg
2
and click on OK .
– With Windows NT, 2000, XP or Vista: select Start > Programs >
Accessories > Dos Prompt , type
ipconfig
", then Enter .
Note the IP address and the mask of the PC’s sub-network.
2 Plug the RJ 45 connector of the 4000 Platform into a hub or
Ethernet switch with a straight-through Ethernet cable
3 On the 4000 Platform:
In the system set-up menu, under I/O interface > Ethernet , select
Config 1 (or 2 / 3 / 4) on the line Mode , then enter the IP address ,
the IP mask of the PC and the IP gateway communicated to you by
the network manager;
Fig. 14 Internet Protocol
Fig. 15 System Setup > Ethernet: Dynamic mode
2.The character _ corresponds to a space.