Viavi MTS 4000 Base Unit, User Manual

Page: 178 / 254

Chapter 10 Scope
New features available with the P5000 and P5000i Scope
156 User Manual 77000000206 Rev. 007
Static pictures
Comment It is possible to add a comment to a picture, just like in
full screen.
File toolbar
The File toolbar is also available in mosaic mode. Actions made by this
toolbar will concern the selected file.
Click on the
F
ILE
button to access the File toolbar on the right of the
screen.
Up to two choices are presented :
Load Refer to "Loading a picture" on page 154
Save This choice is only available if the picture has been
recognised by the system as a Scope picture, either
before opening it or after opening it (pictures created
with different versions). When this choice is available,
refer to
"Saving a picture" on page 153 .
A new loaded picture will take the place of the selected picture, unless:
– the selected picture corresponds to the camera (first position). In
this case, the rule is the same as when a snapshot is made (see
"Camera" on page 155 ).
– free spots are available in the mosaic. In this case, the new picture
takes the second position while other ones are pushed to the next
position.
New features available with the P5000 and P5000i Scope
The P5000/P5000i Digital Probe Microscope is a portable handheld
microscope used to view and inspect both the bulkhead (female) and
patch cord (male) sides of fiber connectors as well as other optical
devices, such as transceivers.
The probe is specially designed to fit and operate comfortably and easily
in-hand, allowing the user to inspect hard-to-reach connectors that are
installed on the back side of patch panels or inside hardware devices.
The P5000/P5000i requires an FBPT inspection tip and is connected to
the 4000 Base Unit with a USB 2.0 connector.
NOTE
Clicking on Save while the camera is selected will both create a snap-
shot (see "Camera" on page 155 ) and save it on disk.