Viavi MTS 4000 Base Unit, User Manual

Page: 157 / 254

Chapter 9 Ethernet TE Testing
Specifying test settings
User Manual 77000000206 Rev. 007 135
This is the type of circuit (media) you are testing: 10M half or full
duplex, 100M half or full duplex, or 1000M half or full duplex.
3 Press the SETUP key to move to the Network Settings.
4 Press the General Network soft key, and then specify the settings.
The following table describes the settings.
5 Press the LAN soft key, and then specify the settings.
The following table describes the settings.
CAUTION: FAULTY RESULTS
Any time the Network settings are changed, the network layer resets.
If you change these settings during a test, you may cause errors in
the test. Only change them before you begin a test.
Setting Description
Emulation Type This specifies the data emulation: whether to
Terminate the line to analyze the data or pass
the data Through after analyzing it.
Network Type Select the network type.
IPoE is IP over Ethernet
PPPoE is PPP over Ethernet
Auto Enable Specify whether to automatically enable the
network layer. If set to Off, you must manually
enable the network by pressing the Enable
Network or PPP Logon soft key.
STUN Enabled
(IPoE network
only) Select Yes or No . STUN allows calls across a
NAT router. Change this only if you know it is
necessary.
Setting Description
IP Mode
(IPoE
networks)
Select either Static or DHCP (dynamic host
configuration protocol).
IP Address
(Static IP mode) Enter the LAN IP address.
Net Mask
(Static IP mode) Enter the net mask address.