19
5.3.4 Mounting of the fuel reservoir
ATTENTION!
In the event that it is installed the supplied wooden fuel reservoir, it is necessary to place a fireproof
bulkhead between it and the boiler.
•
According to Fig no. 15 you must screw the flange of fuel feeder (3) to the lateral part of the fuel
reservoir (6) by using 6 pcs screw M8 x 20 (5), M8 nuts (2) and washers 8.4 (4);
•
Then you must screw together inclined bottom (7) by means of 4 pcs screw M8 x 30 (8), M8 nuts (2) and
washers 8.4 (4);
•
Put the assembled inclined bottom (7) into the fuel tank;
•
Insert the fuel feeder (1) into the flange of fuel feeder (3).
•
The fuel feeder should form an angle of 45 degrees with the horizontal floor in order to ensure optimal
operating conditions. The lower part of the feeder should be placed at the lowest point of fuel reservoir.
The fuel feeder and reservoir must be placed so that there is ensured a safe operation of equipment and
an easy access and maintenance.
ATTENTION: Any change in the angle of the fuel feeder affects the amount of the dosed fuel:
• reduction of the angle will lead to an increased dosing of fuel;
• Increase of the angle will lead to a reduced dosing of fuel;
•
Then position the fuel tank with the fuel feeder in the proximity of the burner so as to prevent clogging of
the transport hose with the pellets during supply of fuel and also to make it possible to open the cleaning
door and ash door.
•
After mounting of the shells (see chap. 5.3.5) interconnect the transport hose with the knee of burner
and secure by means of hose clamps. ps.
Fig. no. 15
The fuel feeder with the supplied fuel reservoir
The assembled
bottom
1
Fuel feeder
1 pc
2
Nut M8
10 pcs
3
Flange of fuel feeder
1 pc
4
Washer 8,4
14 pcs
5
Screw M8x20
6 pcs
6
Fuel reservoir
1 pc
7
Inclined bottom
2 pcs
8
Screw M8x30
4 pcs
