11
Fig. no. 7
Positioning of thermal labels on the burner
4.
Location and installation
4.1
Regulations and directives
The solid fuel boiler can only by mounted by a company holding a valid authorization to install these
equipments.
A project according to the valid regulations must be prepared for the installation.
The heating system must be filled with water that matches the requirements of
Č
SN 07 7401 and
especially its hardness must not exceed the required parameters.
Recommended values
Hardness
mmol/l
1
Ca
2+
mmol/l
0,3
Concentration of total Fe + Mn
mg/l
(0,3)*
*) Recommended value
WARNING!!! The use of anti-freeze mixture is not recommended by the manufacturer.
a) to the heating system
Č
SN 06 0310
Heating systems in buildings – Designing and installation
Č
SN 06 0830
Heating systems in buildings – protecting device
Č
SN 07 7401
Water and steam for thermal energy equipments with working pressure
up to 8 MPa.
EN 303-5
Boilers for central heating – Part 5: Solid fuel boilers for central heating with
manual or automatic feed and max. 500 kW nominal thermal output:
terminology, requirements, testing and marking.
b) to the chimney
Č
SN 73 4201
Chimneys and flue gas ducting– designing, implementation and connection of
fuel consumers.
c) regarding the fire regulations
Č
SN 06 1008
Fire safety of heat installations.
EN 13501-1 +A1
Fire classification of construction products and building elements – Part 1:
Classification using test data from reaction to fire tests
d) to the system of HWS heating
Č
SN 06 0320
Heating systems in buildings – Hot water preparation – Designing and planning
Č
SN 06 0830
Heating systems in buildings – Safety devices.
Č
SN 75 5409
Water installations inside buildings.
e) regarding the electric network
CSN 33 0165
Electrical regulations. Identification of conductors by colours or numerals.
Procedure provisions
Č
SN 33 1500
Electrical regulations; revision of electrical equipments
Reversible thermal
label with indicator of
current temperature
of the body of burner
Irreversible thermal
label
