Vermeer McLaughlin V25, Operator And Maintenance Manual

Page: 107 / 182

V25/VX30G/VSK25/VSK30G Vacuum Excavators Operating the Vacuum Excavator 50-25
Tools and Hoses - Clean
Clean all tools and hoses prior to storage. Debris buildup on tools and hoses will reduce
performance.
Step 1: Connect dirty tool and hoses to spoil tank inlet.
Step 2: Connect spray wand to the high pressure water hose.
Step 3: Start engine and operate at high speed.
Step 4: Turn Water Pump Switch ON.
Step 5: Open Hose Reel ball valve (1). (VSK25-100 is not equipped with Hose Reel
ball valve.)
Step 6: Reduce pressure on spray wand to minimum setting by adjusting the spray
nozzle.
Step 7: Use the spray wand to wash off the tool and hose. (Material on the inside of the tool and hose is
vacuumed into the spoil tank.)
Step 8: Clean remaining hoses with water. Do not spray with high pressure water tools, which can damage
hoses.
Step 9: Check hoses for holes, cracks, etc. Salvage damaged hoses by cutting off damaged section(s). Replace
hoses when necessary.
Step 10: When finished, close Hose Reel ball valve, and turn Water Pump Switch OFF.
Step 11: Squeeze spray wand trigger to release water pressure from water hose.
Step 12: Lower engine speed to idle.
Step 13: Follow the Shutdown Procedure , page 23-1 , and remove ignition key.
Step 14: Securely store all tools and hoses prior to departing.
1