Verilink WANsuite 6450, Reference Manual

Page: 22 / 205

1-8 W A N s u i t e 6 4 5 0
can be set to 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 bps.
The initial default rate of the Supervisory port is 19200 bps.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the Supervisory service acquires the Supervisory port,
after which the port speed is changed to the setting in the Supervisory
interface screen.
NOTICE:
For information on pinout assignments for this connector, refer to
Supervisory Port Pin Assignments on page A-9. See Standard
Equipment on page A-4 for information on cables for this connector.
10/100 Ethernet Port
The WANsuite 6450 provides a single
10/100 ETHERNET
interface port for IP
Gateway, SNMP, and Web browser access. This interface is an eight-pin
modular jack that complies with standard twisted-pair, 10/100Base-T
requirements. The 10/100Base-T cable is supplied by the end user. Refer to
Ethernet Connection Pin Assignments on page A-8 for pin assignments and
cable descriptions.
Ethernet LED Indicators
There are two unlabeled indicator LEDs on either side of the 10/100 Ethernet
jack. The LED on the left side of the jack pulses amber to indicate data
activity (either transmit or receive). The LED on the right side of the jack
lights green to indicate that the link layer is operational.
Serial Port
The
SERIAL
interface port located on the WANsuite 6450 rear panel is a
multi-protocol interface presented physically as a DB-25 connection. The
protocols supported by this interface are RS-232, V.35, V.36, EIA-530, X.21,
and RS-449.
Cables that adapt the DB-25 interface to the 34-pin V.35 interface are
available. DB-25 to DB-25 cables are also available if your installation needs
require them. See Standard Equipment on page A-4 for details. Pin
assignments for the Serial interface are listed in Serial Interface Pin
Assignments, DTE Mode (Packet Use Only) on page A-6 and Serial Interface
Pin Assignments, DCE Mode on page A-7.
CAUTION:
FCC rules require that interconnecting cables carrying high-speed
data be shielded appropriately to minimize radio frequency
interference.